Gigabytes NVR Supported IP Cameras

Works Works with Config Not Working

This list contains a list of IP cameras that have been tested with the Gigabytes NVR. Most cameras that support MJPEG or have a snapshot URL should work with motion-based NVR software (like Gigabytes NVR and MotionEye) but, occasionally, the camera contains some quirk that makes it incompatible or requires special / additional configuration to make it work.

Agasio M1051
URL /videostream.cgi Port  81
User admin Pass
Dlink DCS‑930L, 932L, 934L
URL /video.cgi Port 80
User admin Pass admin
Notes Will DHCP on wired connection first. Can configure wireless from there (where available).
Dlink DCS‑935L
URL  /image/jpeg.cgi Port 80
User  admin Pass
Notes This uses the still image URL.
Tenvis IP602W IP391W
URL  /vjpeg.v?user=operator&pwd=
Port 7777
User admin
Pass  admin
Notes  Gigabytes configures the port to 80
IP Webcam Android App
URL  /video Port  8080
User Pass
Notes  This is an Android app that turns a phone into a webcam.
IP Webcam | IP Webcam Pro
TP-Link TL-SC3130G
URL /jpg/image.jpg Port
User Pass
Linksys WVC54GCA, WVC80N
Sensormatic/ADT OC810
Level One FCS-0040, WCS-0020
URL /img/video.mjpeg Port
User Pass
Amcrest  IP2M-844E
URL MJPEG: /cgi-bin/video.cgi
HD: /cgi-bin/snapshot.cgi
Port 80
User  admin Pass admin
Notes 1. Set Substream to MJPEG
2. Set Main stream to 720p
Foscam FI9851P, FI9853EP, FI9804P, FI9821W
URL Snapshot (HD): /cgi-bin/CGIProxy.fcgi?cmd=snapPicture2&usr=admin&pwd=

MJPEG Init: /cgi-bin/CGIProxy.fcgi?cmd=setSubStreamFormat

MJPEG Stream: /cgi-bin/CGIStream.cgi?cmd=GetMJStream&usr=admin&pwd=

Port 88
User admin Pass
Notes See also: Foscam SetupUse Snapshot URL for HD. Init URL enables MJPEG stream but may not work on cameras with newer firmware. Pan/tilt controls (where applicable) should be operated from camera back-end. User and password must be transmitted in the stream URL (ex. &usr=admin&pwd=1234)
URL /axis-cgi/mjpg/video.cgi Port 80,37777
User  admin Pass 12345
Notes You will need to configure the sub stream for MJPEG and 640×480 before this will work. See also Amcrest IP2M-844E.
Sricam AP003
URL  /videostream.cgi?user=admin&pwd= Port 81
User admin Pass
Notes User and password must be transmitted in the stream URL.
Uniden AppCam21
URL  /videostream.cgi?stream=0 Port  80
User admin Pass 123456
Notes Motion errors: Unrecognized content type Error reading first header – re-trying Wireless SSID: Serial#  Password: 12345678
Tenvis IP391W-HD
URL Currently testing the following URLs:
Port 80
User  admin Pass admin
Notes Use firefox for video: download browser-plugin-vlc from Apper. You may need to disable the Mplayer/gecko plugin so it does not conflict. One of the above URLs is reported to work but we have not tested to verify.

Leave a Reply

Your email address will not be published. Required fields are marked *